Search:

Had the same problem, had the bearing replaced at Hannys, replacement distributor from Honda that I was quoted was some ridiculous figure

Leave it stock till you know what you want from the car first.. dont start modding it just for the sake of modding it... :o

what is the turbo genie muffler???

Mines green and it's a local delivery Si (obviously without auto climate control)

I found Computerline in Preston to be good, they know what they are talking about and seem honest enough... myself and two friends have had suspension bits installed there as well as wheel alignments...

B16 in the jazz? why not just put a K20 in there :o

Since I have registered this is the first time Ive actually read this thread, and who the hells believes what they read on carpoint... thats one shonky site for information.

hell no...

I dont see the relevance in the D15Y being the top model in Msia? The Si was the top model here before the VTi... so what?

15x7s may be illegal for your car seeing that your stock rim width would have been definitely smaller than 6" wide...

you could still put 205s on a 15x6 as you could with a 15x7...

Currently running Yokohama A539s 205/50/15, paid $159 per tyre from Bob Jane (Elizabeth st Melbourne)
So far so good, have only done approx 1500kms on them but feel fairly sticky with minimal...

Another alternative is graphite power, that should do the trick.

I go to jetspeed in clayton. They've been workin on my SiR for a while. I know the one you're talking about, my friend takes his CRX there for servicing. Don't exactly know the addy though. Also...

EK-DC-EG strut tower bar are interchangeable

suspension are interchangeable for the front , the rear need ITR or integra or Jdm EG6/EG2 lower control arm and its all bolt on.

Front seats are...

I can vouch for Hanny Performance, Robert is the man, after being recommended to him and having my car fixed there Ill never take my honda to anywhere else as far as the Sydney area goes :D