Search:

i just fixed my gearbox last week... symptoms were.. rattling noise when clutch pedal down or slipping. Hard to get into gears. This had been like this for 2 years at least but now it was starting to...

i got the bitch pin out recently.. just scratched around for a bolt slightly smaller than the pin and hammered it.. took maybe 10 hits and it was out.

good promo for whiteline!! hahah

it is possible to get them here.
im am definte ive seen them on civics.

GO HOMEMADE TURBO!! haha
good luck with it, i was planning to set one up too but i much prefer a reliable car.

well i think this question has been asked before so a search will help you.

but bassically.. u need to weld on EK radiator support
cut quarter panels above wheel well to join EK panels to EG...

took soooo long to get there and now that you have finished... it just seems a waste to sell it.

Like at least hold onto it for a while so you get the honour of saying you built it and really...

so has the alram ever worked properly before? or have u just installed it and you cant fix the problem?

if you have just installed it i reccomend double check your wiring.. maybe u hooked...

what kind of spriongs did u install?? are they chopped springs?
maybe u didnt install your suspendion parts on the front correctly, double check a manual or something

yeah if u are going to paint it again... you could just rough up the old paint/fix scratches and paint over it.

i can tell you now corona's dont sit in the OEM cupholders when going around a corner !!

i used the hole on the drivers side, bad thing about it though is the power cable running across the firewall with not much to attach it to. But its much easier to get the cable through and into the...

get a whale penis!!

a typical car alternator should be able to provide about 50-60amps
iket is right that the neons only draw about .5 an amp. The fuse is just rated for short circuit protection. Your head lights at...

so what about the coolant drain bolt on the engine block? does anyone take that one off??

I took it off the last time i changed the coolant. It was a bitch to take off too. Maybe a good flushing...

Hey there

nice civic, just wanted to know where and when this show is happening? also how much to get in?

I might be able to go. :)

how much HP does a b18b have? 142hp where the b16a has about 160hp.
I think its basically the b18b doesnt rev as high. it is when u start getting in the high revs the b16a will win.

but for a...

is it possible for them to make the a/c go colder?? the one in my eg sucks!

do what u want with your car!!!!
a lot of the guys here are just JDM fan-boys. :D

well i know in teh EG5 the single hose that goes from teh hole on the pipe goes into the cam cover. Oil vapours get sucked into your air intake and burnt. Its designed so that it doesnt allow oil...

dont the eg5 ones only have one hose going into them? and the b16 ones need 2?

ps. i think u get a plug to fill in the 2nd hole

im pretty sure all b-series motors use the same injectors.. 240cc if i remember correctly.

my vote is the y1/z6.

there is just heaps more support for it. it would be easy to source any hi-performance part for it.

hey is that at stanley park? ;)
and if u are canadian, then the australian civic is basically the acura civic.

i made my own ones using LEDs from jaycar.. didnt have any problems for 3 months.. a bit ghetto but works

the tail light looks like your meant to have the small harnes that u twist on to the lights.