will fit, assuming you get the 32mm hub not the 36mm. people do b series swaps on ek1 without changing the brakes at all so it should work vice versa :D
I work within a dealership and generally fresh new cars are delivered to the workshop with about 7-15 kms on the clock, as a result of moving on the factory floor and on and off the docks and into...
Too much effort getting jdmitr driveshafts to fit, best to go local wreckers and find a driveshaft suited to your car, everything after that should be basically plug and play
yes you would, 1300cc to 1800cc is an increase greater than 15% of original motor specs. will need engineering and then blueslip to register the engine to the car. Costs vary depending on the mods...
Theres a lot of honda support from malaysia - they basically get all the cars that were released in japan. EK9, EG6, DB6, DB8R etc. Since not many people use them now they wreck a lot of hondas;...
are you sure? i had ek4 master cylinder and replaced with dc2r master and booster, all the lines matched up. the only thing that was different was the proprotioning valve. Take a picture and post it...
sprung weight can be reduced in many other ways, unless you've completely stripped your car and have nothing left haha. unsprung weight is more important haha
never heard of any companies that make aftermarket front lower arms, guess they never really needed to; camber can be set with adjustable upper arms, roll centre with the buddyclub adjusters and...
i install reverse sensors all the time at work, unbelievable hwo much they charge for labour because the sensors we are using are just 30 buck kit sensors and it is really, very easy to install them....
I have ek9 swaybars front and rear, imo they're very good for my application, greatly reduces body roll. very noticeable when you take your car to the track/spirited drive
as this guy said, what kind of b18 have you got? Jdm audm c7 c2 c1 c5? look for the engine number on your block exhaust side right near the gear box, then we can probably help out more
just use stock ones, and replace all the bushes with new performance bushes, cost effective. saves you from spending $100+ if you ever bend or snap one. get camber adjustable upper arms, hardrace is...
hey guys, ive been looking around for decent track rims that arent too big for ek, cant seem to find much in 5 lug. Found a set of Godzilla rims for a decent price and just wanting to know if anyone...
try get another master cylinder, if you cant see any leaks/hairline cracks on the slave then im assuming theres an internal leak in the master cylinder. Like the valve that pushes out the fluid may...
Excessive heat from the running engine not being cooled by the coolant could have caused the whole system to pressurise quite a lot, could have ****ed something up.
afaik, all delsol in Australia came out with a b16 engine, so knowing that, a driveshafts from a b series box would definitely not work with a d series box. ask the wreckers for a free replacement of...