Search:

Does anyone have experience with fitting Recaro SPG bucket seats in the EP3 using stock rails? is it just a straight fit with the Recaro side brackets?

Anyone tried them with the Nagisa SLR rails,...

Bilsteins are available for the EP3, B14 series Part No. #47-118768 - this is a complete coilover (uses stock top hats), you can get them from Balance Motorsport in the UK, was around $1350 when I...

These are the part numbers for the 2 denso o2 sensors.

Primary Oxygen Sensor 234-9005 - perfect fit
Secondary Oxygen Sensor 234-4122 - need to extend wires

RCAs could potentially correct the RC location issue, but it wouldn't correct the bumpsteer problem, you actually need a coilover with the steering arm mounted lower on the damper body. Even with the...

Ahh right, I can't think of a situation where you would want the rear to have more static camber than the front, because the double wishbone setup on the rear gives more dynamic camber gain during...

As opposed to what?

Depends what you want to do really, OEM coilovers are more than adequate for street use, after market really isn't going to generate anymore grip...unless you drive like a maniac on the street. If...

Just for clarifications sake (even though it is obvious), the area with the lower temp would be the one not getting enough contact and the area with the higher temp means it's getting too much...

Thanks for that, I'll probably see what I can do with the OEM rods, and go from there.

Does anyone know if it's possible to set the Toe to 0 with a maximum of -3 deg camber (for Front suspension)? This is at stock ride height (345mm from hub centre to guard).

If not, what is the...

Have you considered - http://arkdesign-us.com/products/electronics/mfd-2-multi-function-dash-2

Not sure if you already looked into this device -...