Search:

ring up cbc bearings $50-60 a side and same brand as original

mine has fork type and it aus crx

just get 3 t10 and 3 t5

you can get a chemical test at most mech places they have this chemical they mix with the coolant if exhaust gasses are getting in the coolant it changes colour

might have a punt and get a sump of a integra d16a3 cause its only $40

nsw mt druit area thanks

want to get a sump cause it bottomed out where the plug was and its abit dented on the bottom where the plug goes will it effect it in any way cause its smal dent

does anyone know if an d16a3 integra sump will fit or rover d16a9 cause i can get a sump at the wreckers for $40

and does it crack

i was going to do that but getting another sump would be easier and does the brazing seal well

hi i just want to know if i got a sump off a d16a3 integra would it fit my crx d16a8 as i stripped my sump plug hole i know the gasket is the same and the headers are the same but is the sump the...

to get the hubs off i seen them at mekong all they use is a hammer and a metal pipe wat i do is extension and right size socket and hit the hub out

check if there is a hub ring on your hub as usually with bigger aftermarket wheels they fit these but when you fit the stokies on you have to remove them as the stockies dont need these as the centre...

have u found out yet

the rears are one piece with the hub you cant press new bearings in you have to get the whole hub assembly

or integra or prelude

hi my rear wheel bearing are shot on my 88 crx ed and i want to know if rear hubs off another model
say a civic or a concerto of the same year model will fit thanks

use the long pole to bash the breaker bar theres no need lock the engine just turn it till you get to the compression stroke then give it a good whack with the pole and it should break loose by the...

theres markings on the engine shouldnt need to lock it just make shore you find the markings

your car doesnt ping till under load tappets are noisy all the time on the spot

tried the rattle gun on it

have u tried bashing a smaller single hex socket on yet to get it off works on wheel lock nuts so should work on the sump if its not completely round or u could file the bolt edges down to a 16mm and...

are you talking about the brake light as in the tail lights or the dash one

yeah look under where the brake pedal is theres a switch on top of it when you let the pedal go it touches the switch but there a rubber grommet in between which pops into the pedal the rubber must...

sounds like its your timming is too advanced to me and its pinging get your ignition timming set as you you described it did on a hill with heavy load and when your easy on the throttle it doesnt do...