Hi people,
i need to know if my car is under my parents name and i want to put it under my name what is the process/fees involved?
I've so far only manage to find that i have to treat it as if i...
so it says, "it must be cleared at a full inspection" and "at a AUVIS"?
if thats so, normally just fix the "faults" found and take it to a guy that does blue slips to get it checked and signed off..
lols people who operate the roads and suppose to make it safe seem like they're just bludging it to get their pay..
srsly, who makes the decisions about the tram lanes and bike lanes and crappy...
you need the upper mounts front and rear to use the EDFC.
if you dont have the upper mounts you would have enough clearance on top of the adjustment pin to mount the EDFC motor.
therefore you cant...
if its just a bushing and doesnt come with the "dogbone" peice moulded to it, i wouldnt be bothered.
its a bitch to install. you might as well find one with the dogbone
I think better if you did get new dustcovers and bumpstops. because they are made from rubbers and plastic which over time become brittle and fall apartss.
to check the bumpstops i'd say remove the...
i think... we're all doomed just for even going 1km/h over the limit
i think this is what they meant by "bringing the budget back into surplus"
increase revenue everywhere,
-mobile speed cameras...
i have done this to the holes on my quarter panels. but i roughed up the surface with some 40grit cleaned it, then put 2 layers of fibreglass with resin.
body filled the other side and then sprayed...
Yo, i have replica bride cuga seats in red, with red gradation.
I want to retrim them in
-black suede or black alcantara suede
-red stitching
-black suede or alcantara suede or air mesh for the...
the glue isnt a problem, trade specialists cut that glue like butter.
and with the grinder, you need patience with it.
atleast the job is half done now.hahah
dude thats barely a bar.
umm one method i see people use is a die grinder, but with a cutting disc on the end. should work most efficiently
http://www.rv7blog.com/images/20070428_cutoff_tool.jpg