Search:

Havnt herd anything bad about them and I have project mu slotted rotors sitting at Home got told oem parts are too hard for them

Im after some ebc pads for my vti-r im loctaed in Melbourne

also herd that 96spec itr pads will fit, any one know if this is true?

im thinking of deleting the resonator on my exhaust because it is a really thick aftermarket one that hangs low on my car and my car it quite low already I was wondering if it would sound ricey I...

used both the deodorizer only lasted a day

my cars smelling damp and just bad, just finished a type r conversion in it so wana clean it all up need to find a place in s.e Melbourne that can deodorize it for me

same thing happened to me, you need to either bypass the immobilizer or chip your ecu for a b18cr

bump really need find out whats going on no fuses are blown and cant see anything not earthed

doing a audm type r swap in my honda integra si everythings finished starts and runs but the cluster is playing up any ideas on what is causing it in the video I am turning the headlights on
...

anybody know?

swapping over my cluster and im not to sure where these 2 wires go any help would be much appreciated26587

ok thanks so then the one that it currently connected to the fuse box where does that go?

im currently doing a c7 swap in my vti-r and cant remeber where this power wire goes I have 2 going to one fuse box 1 going to the other and cant figure out the last one please have a look at the...

has anyone else fitted one and what did u use
I used the 3m tape it came with and during hot weather the corners just pop of

where can I get it chipped im melbourne

doing an engine swap in my dc2 taking out my 93 jap spec vti-r out and putting a 99 b18c7
need to know where to get the harness from cant find it anywhere

where can I get the harness from cant find it anywhere

alright so the fuse box out of my vti-r will be fine? they look completly differnt
if thats the case all I need is ecu conversion harnes right :)

also im going from a 93 jap spec si to a 99 audm type r

old engine is out now trying to figure out wiring
since these plugs are cut do u just cut the tape around my old loom and use my old door loom wires or is there a simple was that im missing haja

also have this cut

oh sweet, curiously do u know what it is anyway

26353

ill post up a pic in the morning

about to swap out my b18c2 for a b18c7 and need a wiring diagram as the loom I got with the engine had a plug cut off thanks

off the top of my head I have 4-1 plm narrow headers to a 2.5 inch b pipe and fujitsubo muffler, a short ram
and also have 10.6mm leads coz my old ones died