Search:

same as audm cluster. jus with a mugen wording at the speedo part n a silver color bezel.

http://img.photobucket.com/albums/v474/ccibai/22012009456.jpg

lol...if only u r in msia.. less than aud 400 for the set!

lol thanks for the offer but i m back in msia ady.. i guess i would jus leave it for the time being



Spring Hart CPR.

Hi guys,

I m jus wondering any guys here running on 16 x 8 +32 / 16 x 7 + 32 set up on their DC2R? most prob gonna run 8 inch in front n 7 inch at rear. Jus wanna know whether i will need a lot...

dc2r n ek9 both hv the adjuster knobs on the center, try putting the knob at the door n with the door close, i dun think u will b able to adjust it.

dc5r however if not wrong hv the knobs at the...

do dunlop still makes them? but i remember they r on par with bridgestone re711 n there r pretty good tyres

1 prob with those cheap spring is they tends to hv very high spring rate n they r same rate all round

dunno bout others bout re001 in 195/50/r15 is it in price of per pc o pair? coz tat's y v.exspensive if it is for per pc

IMHO opinion, sway bars r the same, just m ake sure u get the correct reinforcement which atm is ASR brace

if i didn't remember wrongly it did run on full interior, brand new re001 with a lot of front cambers

the whiteline sway u hv, does it comes with no reinforcement? or the old reinforcement? or the new type of reinforcement?

my fren ordered brembo ccx f&r from perfectrun.com.au jus a bit over 500 including shipping if i didn't remember wrongly so i guess u can shop ard a bit more for price

i think the kit dun come with the new heavy duty brace bcoz the brace itself already cost ard $136+ gst while the kit cost $276+gst. u will hv to confirm with whiteline which kind of brace it come...

for itr wheels to fit on ek u hv to swap the steering shaft of the ek to a eg/dc as well

is it jdm dc2r 98 spec drive shaft is a bit bigger? in tearms of 36mm vs 32mm

if i m not wrong 96-98 ek cxi front brake caliper n rotor are a bit smaller as compared to 96-00 gli sedan n 99-00 cxi.

u dun need to remove the axle nut, u will need to remove the caliper 1st which is hold by 2 17mm nut if i remmeber correctly and also the 2 phillips screw on teh rotor as mention by e240, u will...

if u r car is dumped then = no no

http://img.photobucket.com/albums/v474/ccibai/S7300112.jpg

nah, its real. http://www.ssrwheels.com/catalog.html

tried searching for some answers in evolutionm.net or evolutionoz? funny is some ppl get squeals while some don't

if i didn't remember wrongly, u also hv front n rear camber arms right? maybe it will b best for u to get a real good alignment - suspension :P

http://www.ozhonda.com/forum/showthread.php?t=67310

^ yeah same my fren had the same exhaust n it hang tat low as well.

i double check on teh instruction manual of whiteline n i m sure the sway bar will need to bend down in order to avoid hitting the exhaust. but its up to u though :)

yeah mate, the sticker wasn't done properly on the rear sway bar but i guess they did do it right this time. Hv a look at the thread below, it is the 1st prototype installed by whiteline, + i as well...