Is the car registered? Also, make sure there is no money owing on the car, and it's not a written off car, that could be a bit of a hidden cost. Also, you will have to pay stamp duty when...
You may actually find that you get a raise in boost because as you take your foot off the accelerator, the throttle flap closes, and the air stuck between the turbo and the throttle body has nowhere...
The new fast 4's magazine has a pic of it. From what i can tell, there is a throttle flap inside the muffler. When it is open, the muffler acts like a straight through item, when closed, it causes...
If you're going to bring one back, make sure it's stock. The car will still have to pass RTA checks once in Australia. This also means all modifications will need to be road legal as per Australian...
I thought that post was brilliant!!! Granted, mounting a Vortech blower on a honda would prob. take no more than an hour... Experienced workshops would take around 4-6 hours to do a complete honda...
Here's my design. I really think it should say something about what ozhonda is... Care should be taken in making sure all text can be viewed when the hood is up and down.
Oh, and i forgot, there's an LS-1 Ute built by Marks Workshop in WA that uses a Centrifigul Supercharger blowing into a Positive Displacement Supercharger, Woot!!
You really need to calculate the impeller speed of the supercharger, and figure out a safe limit for how much boost the supercharger can make. Spinning the supercharger faster may not necessarily...
I purchased a litre of 2 pack primer, paint and hardener for about $180.00. Enought to paint front lip, side skirts, rear number plate surround and grille. Plenty of paint left over for other...
I'm pretty sure this has been covered in the forums, i removed the glove box, panel underneath the steering wheel, and slid the centre section back. I then removed the centre section, and unbolted...
To my knowledge, CAPA hasn't sold any Vortech Civic Kits in Australia. Only S2000 and 350Z Kits. There have been a few Jackson Racing Kits sold over the years.
I have seriously thought about tracing my factory floor mats out and getting some upholstered. The only thing i can think of with the american mats is that there wont be hole on the right hand mat...
