Search:
Type: Posts; User: RackCity ; Keyword(s):
Search :
Search took 0.00 seconds.
got the car running, so i guess the culprit was the icm.
what might of caused the icm to bum out while driving on the freeway? overheating?
im just worried this might happen again, was i...
Installed the dizzy back on the car and it still won't start, it was making a slightly different noise like something ticking in the dizzy and there was a bit of backfire from the carbs
Damn, so my easiest option would be to just swap over the whole part from the other dizzy?
There doesn't seem to be any screw holding it on the shaft
I'm trying to replace my icm but can't seem to remove the piece in the way? Anyone know how to remove it? http://img.tapatalk.com/d/14/02/09/e7emujam.jpg
yeah got rid of the iab and ran the line straight to the manifold
btw the knock sensors not connected as well but vtec still engages and the car drives fine, just the idle issue at the moment and...
got everything plugged in and the car is running, only problem is that the car is idling very low at 500rpm and always dips after accelerating
no stalling just very low idle and it drops every...
im talking about what number 12 is connected to, thats what i dont have
Don't think there ever was that solenoid, is that right?
http://img386.imageshack.us/img386/2382/gsrvaccumhosediagramoa7.gif
see in that pic, the evap purge control solenoid valve
seems like b18c2 dont have it, is it a usdm thing?
Alright thanks, I've got it now but what is this evac solenoid I see in all the diagrams?
Hey guys, im installing a blox tb and manifold on a b18c2 1994
It didnt come with clear instructions so im just using diagrams off the net,
The problem i have is, i dont know where the hose...
I'm yet to check the icm, but wondering if the icm is bad, can I use one from a d16a8? So an obd0 icm in a carby dizzy.
EDIT: just pulled the dizzy off the car, where is the ICM located in the...
Don't think it has a icm cause I'm using the original carby dizzy
has a mini me swap, with an electric pump
i replaced the ignition coil and still doesnt start, just cranks like before i swapped it
EDIT: still using the d15b4 dizzy
Hey guys,
I was driving my ED6 then it just suddenly died on me, I got it running again after cranking it a couple of times after letting it sit for a bit then it died again 5minutes later.
All...
i think the problem would be is that you sprayed the intake with throttle body cleaner, did you do this while the car was running?
would there need to be adapters if i use a non abs ek9 booster and cylinder?
which car rotors are you using and what is your rear brake setup?
The brake setup is going into a ed6 so the ports will still be the same size as ek9 non asb booster and cylinder right?
But the ports would be flared for a dc2r abs booster and cylinder?
thanks for the response, does it matter if its an abs or non abs 1" brake booster and master cylinder?
Hey guys, would it be fine to run dc2r calipers with a da9 booster and master cylinder?
Or is it a must to upgrade to a dc2r booster and cylinder?
Thanks
would it most likely be the coil and not other things like the ICM?
EDIT: could fouled plugs be an issue for not igniting outside of the car?
the plugs show obvious signs of fouling from...
hey guys,
sprayed TB cleaner in the TB and now the car wont start
had the car running while spraying it but i then turned the car off to spray it in the vacuum valve of the CAI arm.
long...