Search:

Got ek with b16 in it. Got set of pedders in them (most likely sportsryders, which is a 2inch drop). Rear end sits high with two finger gap. Fronts sits just at guard. I've replaced front shocks, but...

Does anyone use/or have used a cargo pod on their civics?

Yeah car wasn't too happy starting. But still running fine..

We're going through insurance. They are assessing the car. So far they've only listed carpet and ecu. I'm worried about the motor plus...

Hi,

Does anyone have an experiences with flood damaged cars? My dads car was in metre high flood waters as the carpark where the car was sitting flooded. Basically the cabin flooded and when we...

Thanks for replies.

Yeah basically an oem rebuild due to wear and tear. 260xxx on clock. Head gasket is on it's way out. Basically wanna replace all that can be replaced.

car is an em1.

engine is b16a2.

Overall quality. Did it run well with no dramas.

Anyone ever had their engine rebuilt? How did it turn out? is it worth it?

thanks for link. Checked wire and D6 is connected to C3. I guess ill just test knock sensor.

Yes it has PCT on sticker.

Is d6 the wire that sits in the last plug go Obd2a?

Hope that works. will have to check ECU code tomorrow.

http://i21.photobucket.com/albums/b288/bull-dave/ECU_zps77e1e336.jpg

So does the Em1 have no knock sensor? Should I just diagnose?

And also my ECU says OBD2a, 96-98 on it. Is that an issue?

Does this mean my knock sensor is faulty or is something else causing a reaction with my Knock sensor?

Yes I was bridging 3 pin. Couldn't see the other. Got code 23- knock sensor. Thanks guys.

Just wanted to add there is no MIL when I start the car. Does that mean no faults detected?

Anyway started it without the MAP sensor and MIL just stayed on. No flashes. No detection? Is my issue...

ECU is off ek9. Ill give it a go. thanks

Found the blue plug on front passenger side. Under the glovebox on the right. Do you think their could be a fault with ECU? ECU is ob2a.

Yeah shoved a paper clip in there. nothing happened

Been trying to get error codes for em1 civic. Bridged the PINS on SCS connector and turned on ignition switch to position 2. MIL just comes on and off like it usually does. No flashes. Any ideas?

can anyone recommend a place for an IACV for b16a in sydney?

Hello,

Having some idle problems in the Em1. Not too long ago car wouldn't start. Brother replaced Rotor and Coil or something like that. Now it starts. But when I start it, motor idles at 1500....

turned out to be coil.

Timing belt was done 20,000kmS ago. Looks like not getting any spark atm. Still a no go.

Hello,

Today I was driving the civic. I heard a Pop from the rear end. Then motor shut off. When I tried to restart I heard crunching from the motor. Now it cranks but can't get it running. All...

Gave the tail lights a good spray, but no leakage.
I have a crack where the Antenna sits. You think water is leaking from there?