Search:

Jason DC2R B18C Yes 12.90 103.00

hey mate, going a bit off topic here, but what exhaust system do you have?

if its custom, who made you the 2.75" ????

let me know if you are going to sell the setup

for all the other people that this could benifit

http://forums.clubrsx.com/showthread.php?t=408654

eastern creek really isnt going to put any more strain on your car any more than wakefield.

B18 - 1800cc
username: blackdc2r
car: black dc2r :p
aspiration: NA
time: 12.9
weight = 1050kg without 84kg driver

K20 - 2000cc
username: BADHBT
car: dc2

i have a red rocker cover that is cut, but in great condition, willing to swap with someone for another red rocker cover that is uncut

i have seen a good driver drive a totally stock s2k around wakefield at 1:13.1

best place in sydney, east coast suspension

dont worry, i have found the details. this one is a little short notice, i will try and make it to one of the following
...

what club is holding the day, i cant find any info on the website that says anything about the track day...

I have a wilwood bias control, brand new in the box, I am open to offers ;)

I really think you should stop posting until you get a time slip

without a time slip, no one really cares.

Once you have a time slip, then you can rub it into all the haters, until then I...

wheel bearing maybe? sounds like a similar sound i had when my wheel bearing was gone

car ran out of fuel after 20 mins? :p

where is your oil temp sensor located?

how did you blow it?

PAR make make stronger boxes. $$$$$$$

wheel bearings?

yeah, cause spoon is so much better :rolleyes:

possible yes, havent herd of anyone doing it yet, you would need brakets made up at minimum by a brake place

pros's: burnout rubber :p

i couldnt tell you what the gains were as several other parts of the car were changed at the same time.

to be honest, i can not remember how much it cost to port and polish.

generally,...

at the end of the day, you will get what you pay.

Adrian at Toda Racing (in Sydney) ported my head, and had it sent of to be serviced.

quality of his work was excellent and any heads i need...

Would you get any value out of spec-d cams for circuit racing applications over spec-c?

i second that:thumbsup: