Search:

why would u want to do dat ???

QLD rego is so fcuken damn cheap ... dat why im still using QLD rego for my eg

im only paying $520 a year for rego WITH greenslip with australia limited or...

just line up some bullet hole stickers where the sensors go

make sure u replace the washers

and always start it by hand

dats b/cos they're slow and no one wants them w/o an snail


sinced u can get turboed cars ... typeR is the way to go

say no to fat chicks and ull b right

lol j/ks

oem honda timing belts are like $70-90

are u sure dat wasnt including labour?

if not ... dats robbery

if i remembered correctly .. its the one on the right had side .. just pull it out

its held in buy 2 clip thingy on the sides ... if its says "turn" on it, u found it ... just like printed in...

ahaha i still have half a dozen cans left over from the days i was painting rocker covers

its next to the steering column ... with all ur other fuses

it says "TURN" on the side of the relay not on the top of it

its a relay in the fuse box under the dash on the driver side

its a square black box dats got "TURN" on it

hey owen, u can borrow my engine crane

pm me if u want it

no need to use sealents on t/b and IM/EM

for the dizzy, u can use abit of rubber grease on the o-ring

yes u use the same IM gasket as wat u have on ur car now...

Im assuming ur engine is a b18c2 ??

if so .. p72 oem gasket .. abt $10-15 from honda

dunno why the yanks didnt put a vtec rocker cover like on the d16y1.. saving cost maybe?

i remove springs without spring compressors ... lol ask JT

rears are 8mm ... did ours last weekend

fronts not sure ..

it should say somewhere on the rotor ... location varies from car to car
the rear inside the hat says 8mm .. havent dont the front...

and wat alot of ppl dont believe is his b20crx use a chipped ecu with vafc2 (wat 99% of ppl consider it as rubbish) and its is road tuned

last time he called me he sed they are getting a dyno, so...

jt .. long ones linke mine long double ring spanners
like 8x10, 12x14, 17x19, 22x24 set???

mine cost $120 a few years ago ... its a must .. the 17x19 is a lil over 1foot so its awsome for tight...

yeah i know ... the trade cateloges we get
they are abt $550 from memory for 1/2" .. or was dat the 3/8

i got a set of Stahlwille metric spanners and set of imperial spanners

i perfer Stahlwille spanners over snap on

but snap on ratchets are the best

some blue point stuff is not rally good ...

like the new blue point engine/4x4 tranny hoist was just abit better quality than the repco one ...

but most the ones we have at work at awsome

i think blues point is from snap-on ....

only seen them sold by the mobile snap-on distributors

Barefootbonzai lol

mine just squeezes in the hole and sit there as the pipe has the wire in it which holds it in place qutie well

i went to long bay a few weeks ago on an arvo caught a cod, eel and some reef fish...

should feed a pipe front front grill/bar to the inlet of airbox like mine ronald

oh and fishing in a few weeks when i get everything done .. promise
lifes been a mess lol