Search:

Rayle your correct about the tank location, they are about 4m underground, under ~500mm concrete also.

I would assume temperature variation would be less than that.

You can probably pick up a china rad for around $120 for half sized, I have used a mishimoto china rad before, and fitment was good!

If your getting a stock replacement, you would be best off...

What?

I hope this things cheap.. I picked up a mostly clean (rear bumper had been hit) EF7, ZC etc for $1500, there are some cheap ones to be had it seems.

With the Alloy rad, straight forward fitment and installation will be dependant on the quality of the kit, so see if you can get a review or what not before you buy, with a decent one, it's an easy...

not necessarily, the colder air is denser in comparison, so the ecu should be putting more fuel in to retain a good air fuel ratio..


But a better filter and free-flowing exhaust will improve...

Just to add to this, i have a similar issue on my B16, not that its a bad thing, but 5k at 110 can get a bit tedious at times..

I'm thinking taller ratio box when I move onto B20..

The BC coil overs are constructed in the same factory as GReddy, although they are not Japanese made, they are still pretty well made, considering their cost, I tend to buy a higher range of...

I first purchased an '01 DC2R when I was on my P's, just recently I have purchased an EG, and I feel like this is what I should have gone with in the first place.
The EG will make a GREAT first car,...

Sounds like a cold start problem,

The valve/sensor is under the TB i think?

Take a photo, and give a better explanation.

3 Mounting bolts don't line up?

Or your intake pipe to the airbox/filter?

Thats the only tips i can give you at the moment.

I used some Sea-Foam on my DC2R, idle was steadier. It also made the car feel a bit smoother, and the TB and intake manifold wear totally clear of carbon, oil and discoloration. worked perfectly....

This will probably be the problem, too often after quick head unit installations people lose parkers, and cluster illumination.

Make your your wires are properly insulated, and are not crushed...

You will have to remove the headlights, place it in the oven to get the sealant too heat up tot he lense can be removes, wet sand the inside and outside of the lense with 2000 grip wet and dry, then...

The leak in the from could be caused by this, check the condition of the rubber lines to the heater core, and replace if just the edge is damaged, you can cut back the line, around a cm will not...

thats a 4AC, a 4AFC is a twincam, carby AE92 motor,
nub.

LOLcano

Hey im jack, some of you know me, and some know me off jdmst = J


So yeah, i dont have a Honda, because, well vtecmachine drives one, and i dont want to be like him.

Im from North shore of...