Search:

Yeah i agree but i'm considering head work before i get a tune, works out cheaper in the long run :)

After manually adjusting the IACV (same as tps, loosen 2 screws and adjust positive or negative then tighten), the hunting issue has stopped and my idle is constantly 900rpm while rolling and even...

Alright guys, i replaced my 26mm EP3 front sway bar with AUDM 24mm DC5R sway bar, rubber mounts and brackets. This gave me 4-5cm more clearance at the top of the 2-1 pipes. Result = NO MORE KNOCKING...

I've got a 2002 EP3R, i've heard DC5R sway bar on EP3 is a fix, vice versa.. So PLM headers + DC5R model with EP3R sway bar makes no contact same as PLM headers + EP3R model with DC5R sway bar also...

It's not hitting the chassis rail, it's 100% the sway bar. I've got a good 3-4cm clearance on the subframe but only 4-5mm on the sway bar :(

I'm running PLM Headers and OEM front sway bar.

i've got some pretty annoying knocks of the sway bar on the headers, i've got Hardrace 88A mounts, so the it's the sway bar knocking the headers as...

Nah he didn't end up doing it, he sold the car a few months after he blew the head gasket :)

If it was a tune problem, it would have appeared the minute i installed the throttle body and manifold. Not 3 months and 10,000km after. So nah not /thread.

Nah i'm running OEM ecu

I spent some hours on it today :)

Cleaned IACV (again)
New spark plugs
injectors flushed
replaced pod filter and cleaned hydro shield


The problem is still there however :( I also have a...

Hi guys,

I've got a 02 CTR and i've got a slight hunting problem which only occurs once the car is warmed up and usually after sitting on the highway or at a consistent RPM for more than 10...

CW EP3 sydney :D