Search:

dear ozhonda forum, this would be my first post on this subforum as i just purchased a cl9 and thinking of modding bits and pieces of it and though it would be at peace of mind if i have a service...

the jazz vtec work in a way which the second lobe engages a second valve at 2560 (from memory) rpm it increases flow at higher rpm. preety much at low rpm u would want a less air going in and out to...

hmm cheers guys will surely look into that, but 1k abit iffy atm,

tru thats abit exy but how would i go about replacing pads for them though? same as front? specialised rear pads for the jazz from t1r?

I've been having my gd for a while now and been driving around but just notice the new jazz having disc brakes on the rear. I got jealous so im woundeirng if it is possible to use these on the older...

Dear all i have a problem,

I have unplugged my car battery and disconnected the rear harness for my cd player (pioneer deh 6950IB) to change the cd player's location on the double din. in the...

similar engine to a jazz, just unbolt the airbox get a silicone elbow and connect a pod filter on, cost about 30 bucks total. but dunt go abouts cutting into an stock parts just incase u need to use...

troubleshoot it swapping the Left bulb with the right ballast and vice versa if one works then then u noe its the faulty bulb or faulty ballast,

jazz power about 25-60 watts not even that - power to power the dyn speakers, 100w rms, i ran them off a 260 watt at 4 ohm amp.

ryan i dunno what your on about man, lol but but unfortunately i have tried the local pannel beater n they charge 50 bucks per housing, seems abit pricey but i'll keep looking around, might go...

thanks for your suggestion mnc, but i already tried buying chrome paint in a can but it turns out matt silver? yea looks like aluminium instead of chrome, but as much as i like diy i think this needs...

bump can someone plz help?

hello all,

i have purchased a pair of projector headlights on this forum some time ago, i'm modding it to fit angel eyes in but when i opened the projector housing, the reflector (where the bulb...

verrrrrrrry interested please pm if this is in brissy or even sydney. lol

did u mean a high pass (hp) and low pass (lp) filters which cuts frequencies above and below a desired frequency. the trick to 'hide' the sub's location is to set the sub low pass filter to anything...

i recomend anything from jl (but it must be the slash or hd series) for approximately 150 rms at 4 ohms is suitable for most 6.5 inch splits.

the current ones look to me like soft silicone than oem which looks like butyl rubber.

awesome, thanks dude, i read up on the manufacture's home page i reckon the sikalastomer 710 or 711 works better since its formulated for the automotive industry, but where can i get my hands on...

damn snug fit, how much did that cost u?

same thing happened on freinds ek, its now leaking cause of a dodgey job. i wanted to help him take it appart but its gone full hard. lol. i searched online and there nothing suitable aswell. they...

silicone is best sealant, and gives the best seal but thing is it might provide such a good seal it'll be a bitch to take apart if something happens l8r dwn the track.

totally agree, i already checked the diy section its all about polishing the exterior nothing about doing it internally. ie requiring to dissamble the unit. the glue's like very sticky very stretchy...

so i just picked up myself a set of hid projectors from another member on the forum and i found that the plastic is foggy on the inside. I decided to remove the plastic off by prying along the edges....

sounds like they compressed ur springs?

which bar?? where's wally