Search:

front fit rears have to have the locator in the bush in the lca shaved

hey guys im wondering if anyone has done the front end conversion or knows if it ill fit up.. from wat i see the gaurds should line up but unsure of the bonnet bar and lights any help would be good...

also if ur fluid is black and has lost its viscosity as a fluid it may not read as havin fluid if the above ppl hav said does work

hmmm with out hearing it i wouldnt be able to diagnose it

rod knockin did u put the correct level of oil in it ??? did u leave somthing unplugged?? i hav a d16y1 in my car and i have never heard a knock even under the punishment i give it.. just check all...

exactly but wat i was sayin was to not waste money on the covers when he can just paint them

the covers are more of a waste of time my suggestion is to take them off clean them with brake cleaner or carby cleaner get some red caliper paint and spray them then find some brembo stickers

where bouts u located in nsw??

get ur tape measure out. are u thinking of upgrading or something???

welcome nice to see another EH9 on here

or if u have a towbar wiring harness they also play up

could be wiring issue or flasher relay playin up test the switch circuit in the relay.. also bulb could be about to blow causing more resistance

or you could go with some ghetto steal rods made up amd brackets and solid top mount to the hight you want imnot sure its safe but you want it low and not to bounce and hit ground but it will be a...

does ur interior light work or your cig lighter still or did they go aswell.. where bouts u located at

did they fill the gas to the correct amount did they change the the reciever dryer.. if all this i suggest possibly changing the ac compressor and regasing it

check your plugs hav the correct gap and correct plugs for ur car.. check the timing also. maybe clean ur throttle body and clean ur pod then if it still runs rich then start replacing things.. as...

or it could hav a 0.9 bar like my vti just check if the seal has a short rod or a long one if it is short u hav a 1.1 if u hav a long one its a 0.9

yes thats right the gaurds hav to be modified or swaped to fit them.. centre console can be swapped and maybe rear seat base only.. carpets can be aswell

seats can.. front bar lights bonnet gaurds can fit i hav been told its possible.. door panels dont fit

could be vtec solenoid, vtec pressure sensor etc or even dizzy giving way my old 4th gen did this i had to replace engine loom dizzy vtec soleniod and ecu
is urs manual or auto

the moderators are here to keep it under control and keep the posts in the CORRECT sections, if u get an infraction or more u hav done something wrong repeatedly and u didnt listen as far as being a...

i hav a 89 crx with the vin 6a91nvest98009027 wtf and its ment to hav a zc but the engine numbers 6a9hw09010

i did my own h23 to h22 conversion and now hav turboed it ull love it

i hav a 4th gen for sale in forsale thread its manual si with h22a conversion in nsw

i hav a 4th gen bb2 si with a jdm h22a conversion in it with konieg hotswap 17x7s, half custom extractors, aem cai, a tanabe front strut brace and a drift cannon lookin 2 sell maybe.. the 4ws is a...