EK9 Suspension on DC2

[vinnY]

that may be the case for dc2r's, but for regular dc2/dc4 and eg-everything-but-6 i believe you should be able to swap the shock bushing out on the control arms

but yes you can't swap out the entire arm because the dc/eg arms are shorter than the ek ones
you'll get fully sick negative camber if you swap on the ek arms on to a dc/eg if it's possible at all

just found this post from leo confirming what i had mentioned above..

[squish85]

Thanks alot Vinny !!

[EG5]

Function 7 have them for your car
We are their Authorised dealer for Australia
It allow you to run dc2r suspension on EK civic

[vinnY]

he wants to go the other way yonas
ek9 on dc2

fork to fork but different sized bushings is stopping him

[EG5]

he wants to go the other way yonas
ek9 on dc2

fork to fork but different sized bushings is stopping him

Whoops my bad

[squish85]

Thanks for clarifying Vinny

[squish85]

Alright guys, I have found further evidence supporting Vinny's theory. EK9 rear coilovers (aftermarket) will fit DC2.. However, DC2 (NOT R) rear coilover will NOT fit on a EK9 due to the difference in the alignment of the bolt holes. On a EK, the bolt holes of the DC2 rear coilover is too short and cannot reach low enough to be bolted.

Here is the link http://www.honda-tech.com/showthread.php?p=36777123

Hope that this may be marked as a sticky for future references