EK CF-look Instrument Bezel

[Vtec R]

just buy the real deal lol no headache

[turtle187]

rofl no fun if you buy the real deal theres no DIY!

[XP02ED]

nice work on both DIY's dude, does the vinyl bend on rounded spots?

[jpestrada115]

rofl no fun if you buy the real deal theres no DIY!

yeah, it was for the fun of the DIY.

nice work on both DIY's dude, does the vinyl bend on rounded spots?

thanks. yes it will - have to heat it up a bit with the hair blower to make it a bit softer and give it some flex to bend and wrap around rounded spots.

[XP02ED]

might have to grab 1 aye, my sisters there atm might try some DIY with some interior bits.

[rey2009]

nice DIY!

where did u get this self adhesive cf from?

[jpestrada115]

nice DIY!

where did u get this self adhesive cf from?

from the philippines mate. but there's similar stuff in autobarn.

[rey2009]

wow

u mean u can get this stuff in autobarn????

like carbon fibre sheet?

[Premature Vtec]

+1 for u good stuf

[jdmlvn]

ive seen some hondas on honda-tech putting a layer of clearcoat over the top of it to give it a glossy finish

[dougie_504]

Excellent. Very intricate work there around the holes and edges. I like it, rep for you.

[jpestrada115]

ive seen some hondas on honda-tech putting a layer of clearcoat over the top of it to give it a glossy finish

good idea. if you clear coat the back part of it as well, i'm pretty sure that the clearcoat will also seal and hold the tiny flaps around the holes that was stuck around the edge and to the back.

Excellent. Very intricate work there around the holes and edges. I like it, rep for you.

cheers mate. in fact the holes was the hardest part of the DIY.