Hi Guys,

I'm looking at rebuilding the engine in my 98 EK1. Its a D16Y4 and its just done over 250000 km's i'm just looking for suggestions for what parts i should run in it. I'm looking to replace rods pistons, apparently i read somewhere (on here or turbod16.com) that this is the weakness in these motors. i want to build it to either turbo or even supercharge. But this wont be till later.

So basically i'm planning on buying another D16 Motor and rebuilding it then doing the transplant. so i'm after ideas as to what go fast bits would be good for the rebuild.