Opinions...

[Twincam16]

Tyga rear seat kit

from...



to this... (excuse the awesome photochopping)

[lo0se3r]

HOT, tyga have always been making awesome after market kits

only problem that i see on alot of the cbr250 with only the tyga tail is that the front looks too out dated with the sharp tail..

the rvf tho... doesnt look half bad

why not the full kit?

[Twincam16]

Headlights are too sharp, not a big fan. Also prefer it to look heavy up front, and clean at rear

[Gawdam]

+1 on the tyga rear.. looks great with the 400. Not so much 250.
What would top it off is the 2 exhausts on the same side of the bike.
That looks awesome. Not sure if its on this bike that I saw it.

[Twincam16]

Yeah its about 2 grand for the full system though...

[rodericb]

I wouldn't do anything to a RVF400 - they're absolutely gorgeous looking bikes. An old basher of a VFR400 yeah, but not a nice RVF!

[Gawdam]

Yeah its about 2 grand for the full system though...

Shit... for the exhaust????

[SHOGUNOVDDRK]

My 2" moved George, Do it.

[Twincam16]

bahaha!

[gumbs]

Do you get rego an cheaper in NSW for being a single seater?

Remember you'll need to get that engineered and rip the rear pegs off.

Personally I wouldn't do it, your losing the tiny ammount of storage you have on a bike. Where are you going to keep your basic tools?

That seats going to ****ing suck on a long ride.

[lo0se3r]

ummm do you have to get it re-engineered?? i dont think so mate

hmmm my mate bought a 08 cbr 600 and then wacked on a rear cowl... no engineering needed

[gumbs]

A rear cowl can be removed and the seat put back on. It may different for nsw, but up here you would have to get it engineered for solo rego it only cost $150 or so here and saves you $200 a year on your rego but I don't think you get the discount down there.