Disclaimer: The following is provided as a GUIDE ONLY, and neither myself nor Ozhonda take any responsibility for the outcomes of someone else doing the following. You follow these steps at your own risk!
Aim: Change your front parkers + low beams =D
Required:
* T10 (leds) x 2 [ i chose white]
* Flat head screwdriver
* HB4 bulbs for the low beam
* Tissue/cloth - don't touch the bulbs with your bare hands
* Gloves if ur a wuss =P
* Patience with the rad overflow bottle..
Steps:
1. To do the left hand side lights - full-lock the car to the right.
2. Damn dunno what happened this pics focus is =\ .. anyhoo, use your flathead and take off the 3 circled screws
3. After you've removed the screw/clip like things holding the weather guard in. Place them somewhere you won't forget/lose and then pull the lining down.
4. Look in and you will see the bulb with connector at the bottom. To remove the stock bulb, push the tab in the middle down (blue arrow) and pull the connector down at the same time. Turn the bulb anti-clockwise to looses it and pull it out. - Be careful not to touch the actual 'bulb' part with your bare hands, use a tissue if your scrared.
5. Take out your new hb4 bulb and put it in + turn 1/4 clockwise - you will feel it go hard (teheheeheheheh) dunno how to explain but you'll feel it go into its thread and sit tight. Push connector onto it and turn the headlights on to see if they are working.
6. Ok now onto the left hand side parker - be warned this is a b!atch because of the overflow rad bottle haha.
7. The overflow bottle will slide directly up, reach down to the bottom-most wire and wriggle it if you are unsure its the parker. Turn it 1/4 turn anti-clockwise and then use a tissue/cloth to pull out the stock bulb.
8. Push your new parker in until it bottoms and turn the parkers on to see if it works. If everythings ok then you now have to wriggle the rad overflow bottle back into the clip holding it.
Put the clips/screw like things back in to hold the weather guard in place and then hop into the car, turn it on and full-lock it to the left to do the right hand side.
9. Repeat the steps previously listed. Right hand side is so much easier because no overflow rad to fiddle with so shouldn't take long.
10. Once you're done sit back and enjoy haha!
P.S - pics to come 2moro, camera died and needs charging + off to work soon
there's only a few which i had saved..
Bookmarks