behtec_junkie and yboost new pb

[beeza]

O yeah!

Will check em' out in a hour when I get on the comp with audio!

[Behtec_JunKIE]

wow details on your car behtec junkie motor specs weight suspension setup etc! very close to 12's with b series?!

thanks man
my motor is stock internally i have a dc2r k&n airfilter and box with a diy piping and toda headers with 2.5inch exhaust, and have apexi n1 coilovers with a power fc tunned by joe from hi comp wid a best of 118.5 kw
i didnt get to weight it wish i could have

and thanks for all the comments guys

[beeza]

WHAT!!! simple combination of mods!!!

Just like Dazza (EK4-guy).Simple mods! Therefore 90% of the parts are OEM!!

[damo46]

hey man few questions on the crx.... what rpm where you luanching at? also what tyres and tyre pressure??

B18CR all the way!!!!!!

[destrukshn]

what tyres are you guys running to get these times?

[iijjee]

Congrats guys! What tyres on the crx? Also keen on launch rpm!

yboost... how are those d'shafts holding up on slicks! Lovethat ur half a second off a $400,000 600+hp Turbo GT2 Porsche in a NA 4cyl. FWD car!

What redline are you both running??

(and what's the cai secret - I'm sick of the radiator fan blowing straight at my K&N!!!)

[Benson]

Shafts wont break unless you bog it. Dont be scare to give it some RPM's. Im sure yboost wont have that problem with high rpms launches and launch control

[EG5]

Shafts wont break unless you bog it. Dont be scare to give it some RPM's. Im sure yboost wont have that problem with high rpms launches and launch control

Enough said

High rpm launch will not kill the axles or CV joints as long as its done properly.
We did 7250 rpm launch on 24.5 inch slicks @ 7.5 psi on the slicks ( Still running OEM Honda DC5R axles for over 100 passes down the 1/4 mile)

[YBOOST]

the shafts are holding up good with 7000rpm launch with a bit of wheelspin. my car redlines at 8900rpm but i shift at 8500rpm.

behtec's crx redlines at 9000rpm and im pretty sure he shifts at 9000rpm. its a very quick car for 118kwatw!

[Behtec_JunKIE]

this was my first nite out since i finished the setup so im still tryin to figure out my launching
13.2 i launched at 2500rpm stil big wheelspin
13.8 at 3500 and i thinks its too much so i half throttle it half way through 1st ( missshifted so time sucked)
13.5 was at 2700rpm i think this launch was gud but i misshifted
my tyre pressure was 20 to 21 was too lazy to drop it lol
and my tyres are dunlop full streets not semis

(and what's the cai secret - I'm sick of the radiator fan blowing straight at my K&N!!!)

thanks and btw there is none i jst have stock dc2 air box wid extra piping to make it breath easier lol

[denrie]

Congrats Irah & Damo. Both really good drivers!

[iijjee]

Can't wait to find out how much that crx weighs! My EG is 1050kg without driver - just weighed. Could prob get it to 990kg without seat and spare etc. My guess is that behtec is about 890kg plus driver!