Hi all,
Got a chance to pickup an Alaniz head which are apparently one of the better heads around with a street port -- Looking a Jun Type 3 cams ..
Question is and I've looked high and low with varied comments:
On a stock bottom end, is the Jun Type 3 too aggressive for stock bottom end? I don't want rev limited much higher than 9100rpm and I understand these cams make power through to around 9000rpm?
I also understand you really need CR of around 11.5:1 - 12.5:1 for these cams to really shine, given basic .020" machining, stock CR should approach 11.5:1 yeah?
From people with experience out there -- What are your thoughts? Apparently Jun Type 3 is like a Toda B, but can get a good deal on the Jun shafts..
Bookmarks