they can be made to fit but the stitching on the seats won't line up with the top and bottom sections, can be made but it needs to be modified, threads on hondatech as to what people have done in the usa (retrimming the seats in my honest opinion would look alot better)
depends if its hatch or sedan as well - hatch u can make them fit ... but sedan u will need to get some DB8 Type-R seats
oh really!! awsome becasue mines a hatch. will look into this. cheers
Originally Posted by EK1.6LCIV
they can be made to fit but the stitching on the seats won't line up with the top and bottom sections, can be made but it needs to be modified, threads on hondatech as to what people have done in the usa (retrimming the seats in my honest opinion would look alot better)
yeh re trim will look good as i actually like the ek4 seats but the pattern on them is just the worst. cheers
If uncle Jack helped you off an elephant, would you help uncle JACK OFF an elephant???
If I'm not back in 5 minutes..............just wait longer
so all holes/screws/nuts etc. will align but just will have gaps? thats alright as long as the gaps arnt to big
Mainly you will have gaps between the sides from the shoulder to the thigh knee area on the rear dc2r chairs. I have test fitted them on my ek4 what people do is buy foam and put it between the gaps.
they will fit.. theres just a gap in the bottom between the backrest and the actual seat. i had itr seats in mine. the backrest is a good fit, just the seat has the gap on the sides 2.
HORSEPOWER is how hard you hit the wall.
TORQUE is how far you go through it!
Bookmarks