avalance 4 channel 800w amp

[michael_antoi]

i just bought this amp and was wondering if it was possible to bridge all four channels.

would i need that much wrms to run my clarion pa12-s which is rated at 300w continuous output or would bridging 2 channels be fine?

the model number on the amp is av800

[bumography]

it is possible
however,
only the rear channel has a low pass

only thing u can do is bridge your rear channel-->lowpass-->Clarion sub

the other two channels can just sit there or you can use for a pair of speakers

[michael_antoi]

that's not bridging 4 channels.....is it?

[bumography]

if your amp is a 4channel amp
u cannot bridge it to 1 channel
u can bridge it to 2 channels.

u can bridge the front channels, but in this case with this amp its pointless. unless you use an active low-pass filter,
and no, you cannot bridge all 4 channels to this one sub. (assuming its SVC 4ohm)

[michael_antoi]

ok thanks for that....

i'm just gonna bridge 2 channels and run my sub off that...