EG6 Honda Access Front Lip

**Red_EG4** · 13-05-2010 05:44 PM

I did a search for this but couldn't find what I needed.
I went into Honda and got myself an EG6 Front Lip(for my EG4 Hatch), but it's not fitting as well as others I've seen.
My understanding is that it should fit all the way up over the exposed plastic at the base of the front bumper to meet flush with the bottom of my paint.
My lip isn't reaching that far up, is there a trick to it?

**quangsuke** · 13-05-2010 05:58 PM

any photos?
im getting mine tomorrow.

**Red_EG4** · 13-05-2010 07:05 PM

**riruiz_88** · 13-05-2010 07:06 PM

yeh thats normal man, i asked the same thing we i first got mine. reason you dont see the black line on most US hondas, they get resprays. its all good man, just try push it up as much as you can and either screw/zip tie the ends of the lip.

**Red_EG4** · 13-05-2010 07:14 PM

Thanks, bit disappointing really.
I looked EGK24A and it appears to have little to no gap before and after respray.

**90LAN** · 13-05-2010 07:22 PM

u mite not have a oem honda bar
which has a shit mould to it

anyway it shouldnt sit all the way up
but can be done with some help and screws

**Red_EG4** · 13-05-2010 07:26 PM

bar has Honda markings and make dates on it.
so the ones that sit right up have extra mounting hardware?

**eg5civic** · 13-05-2010 07:51 PM

mines exactly the same man

all you do is, as your screwing it onto the bumper push the lip upwards and tighten the bolt. I still have a small gap, will take a photo and upload tomorrow

still looks goot

**90LAN** · 13-05-2010 07:54 PM

try cleaning your bar
mite make a difference in the way it looks

**yeung** · 13-05-2010 08:11 PM

Mine doesn't go all the way up either, refer to the pic.. it's not that bad though

Cheers!

**Red_EG4** · 13-05-2010 09:06 PM

bar was cleaned after taking the pics, doesn't really matter though cos the locusts will still be out there for another round tomorrow
thanks for the input guys