Hey guys, I'm wondering if any of u get any leaks with this header? I just installed mine last week with new hi flow cat converter, and hks silent hi power exhaust. Apparently there is leaks at the slip joint. I am very sure about this. My mechanic confirmed that too. What's the best solution to seal it? I am thinking of disassembling and applying high temperature RTV red silicone around the joint and assemble the headers again.

I've done abit of research and found that some people were successful using that method. I don't really want to weld it because it will create stress on other areas and make the header to crack.

The cost to take disassemble and assemble is quite exp. I got quoted 200-250$. Its also not guaranteed if the sealant will work. What do u guys think?