***Official What did you do to your EK today***

[tangk]

Plans are:
YCP 75.5mm piston
Skunk2 Rods 138.62mm
arp rods/bolts (already had head bolts in)
Machine, Deck, Hone block
Machine Head flat

Tempting me to start my turbo build haha!
Just wondering have you got a rough idea how much/where you'll get the honing done?

[mugen_ctr]

Tempting me to start my turbo build haha!
Just wondering have you got a rough idea how much/where you'll get the honing done?

I got a place up in tullamarine that does machine work, all up including notching the block as well, give or take, 550 - 650, so not too bad

And yes every one must boost! LOL honda + boost = funnest thing ever!

[grifty]

DIY Port n polish @ mugen_ctr

I want to do 10.5-11:1 comp ratio on my JRSC mini me with forged rods and pistons later down the track.

[mocchi]

I got a place up in tullamarine that does machine work, all up including notching the block as well, give or take, 550 - 650, so not too bad

And yes every one must boost! LOL honda + boost = funnest thing ever!

so abt 600 to bore the block, hone it and machine head + block surface?
sounds cheap.

[cbauto]

DIY Port n polish @ mugen_ctr

I want to do 10.5-11:1 comp ratio on my JRSC mini me with forged rods and pistons later down the track.

heading into 14's

Shiiiieeeeettttttt unknown territory.

gud lik maniguh

[grifty]

M8 I don't even anymore

[Vvvtec]

DIY Port n polish @ mugen_ctr

I want to do 10.5-11:1 comp ratio on my JRSC mini me with forged rods and pistons later down the track.

[RenzokukenJ]

heading into 14's

Shiiiieeeeettttttt unknown territory.

gud lik maniguh

Little cheeky fuk

[cbauto]

Little cheeky fuk

[tangk]

[cbauto]

[mugen_ctr]

so abt 600 to bore the block, hone it and machine head + block surface?
sounds cheap.

so far ive been quoted hahaha, fingers cross it wont cost any more