AP2 bumpers on AP1

**JN7** · 22-11-2010 07:53 PM

Just wondering if its been done by anyone here or if anyone has any info about the change
In shortness - will ap2 front and rear bars will fit onto ap1 fine?

And also, is it right that ap2 front bars don't have hid washers

and finally, what's the price differnce between AP1 front bumper and Lip cmpared to the ap2 bumper and lip

**ludecrs** · 22-11-2010 08:07 PM

Been done by a few here.
It all fits - except you may have to shave a corner or 2 off the support bar as my JDM AP2 front found out the hard way when I got dimples from the sharp corners.

JDM / USDM dont have HID washers - UK and AUS do.

AP1 front bumper primered: $600ish
AP1 front lip painted: $700ish

AP2 front bumper primered: $700ish
Ap2 front lip: $not sure

I got my ap2 bumper & lip out of Japan auction site for $550 delivered - but i was lucky.

**ludecrs** · 22-11-2010 08:09 PM

A quick looksee in the FAQ topic reveals this very topic having been covered..
Direct link:
http://www.ozhonda.com/forum/showthread.php?t=43872

**lzybum** · 22-11-2010 11:34 PM

got my ap2 front bar from honda
straight fit basically and didn't need to shave any corners from the support bar, although i didn't put back on the foamy part that sits in front of it.

ap2 rear bar fits too, no hassles, all bolts line up except the two right at the bottom.
the ap2 rear is taller, height wise (i think) so when u try to put the stock bolts back on at the bottom, theres a 10cm-ish gap.
all u need is 2 brackets to fill up that gap and ur sweet, or if ur lazy leave it out like i did and the rear bar's free to shake when u wash the car lol. might look flimsy but its still there atm.

**JN7** · 22-11-2010 11:37 PM

Oh sweet, my panel beater should be able to sort that out.
Sounds like something small.

So the price difference between AP1 and AP2 front bar, front lip and rear bars don't vary by much?