another Hondata question!!

[Alexplicit]

hey guys. got my new ecu in and running, and it came with a set button. so i decided to hook up launch control.

i have a few issues. first of all when i hook up hondalogger, it connects for a split second then says connection error. it has datalogging unlocked.

secondly, the big issue! the launch control. i bought and tried 2 different stop light switches. so its not that.

i push the button, light flashes once, i then bring revs up to desired launch point, quickly press brake pedal, push clutch in, and the car revs past the launch point?

what is going on!!!

[dc2r-0636]

see if this thread helps bro, http://www.ozhonda.com/forum/showthr...0-Hondata-S300

[TODA AU]

Hondalogger? Are you using an S200?

[Alexplicit]

Yes s200, I wnt and got another switch, I got an actual clutch switch this time
So I have tried both cruise control switch and brake light switch can get it to work momentarily, like rev- bounce then it goes to limiter

[TODA AU]

You need the following:
http://hondata.com/updates/?app=rome...ction=download
http://hondata.com/updates/FTDIUSBFixSetup.exe
+
Hondata RomEditor4 cable

+ http://www.moates.net/ostrich-20-the....html?cPath=95
+http://www.moates.net/burn2-chip-pro....html?cPath=94

The launch control needs to be set through programing the chip.
It can be set 2 ways, through the use of the clutch switch or via VSS
The VSS method is easier & frees up your clutch switch for gear change ignition cut.

NB: Hondalogger software cannot change S200 settings or chip programme settings
Use above listed software & products to re-write your chip & activate launch control.

To read the chip, insert chip into chip burner & read chip.
Then save buffer to file.
Buffer is a binary file, so when searching to open it when done, change file type setting to ".bin"
Open file, change settings & burn chip via Rom Editor4 software

Or go & see someone who knows how to do this.
Hope that helps.

[Alexplicit]

hey toda thanks heaps. actually got it working without that. just started working only problem now is, launch control only works once. only for the first time i use the clutch. if i want to reuse i must turn ignition off and then on again.

and also. when i connect to hondalogger, i have to raise error limit to ten. and then it connects but doesnt show any realtime information everything is on zero