DIY type R look doors on a vtir stage 1!

**GIPONU** · 25-03-2011 07:55 PM

i have done this to the holes on my quarter panels. but i roughed up the surface with some 40grit cleaned it, then put 2 layers of fibreglass with resin.
body filled the other side and then sprayed high-fill with flexible additive. its been so good so far.. and its been 2 years

**VTI-RRR** · 25-03-2011 10:00 PM

Originally Posted by GIPONU

i have done this to the holes on my quarter panels. but i roughed up the surface with some 40grit cleaned it, then put 2 layers of fibreglass with resin.
body filled the other side and then sprayed high-fill with flexible additive. its been so good so far.. and its been 2 years

Thanks for that I'm glad it works

and yes I forgot to mention I did use sand papper and I did 3-4 layers.