XFORCE Exhuast systems and headers for Honda Civic EG, EK & EJ Review

[matespace]

Xforce exhaust systems are designed to be a true bolt-on option and power gainer. All exhaust systems are R&D in-house and dyno tested with proven power gains. 304 Stainless steel mandrel bends, and flanges are used in the construction for its strength, excellent heat resistant,, rust proof, high flow (mandrel bends) and finish properties. Everything in the Xforce range includes bolts, nuts, gaskets and everything else needed for a true bolt on experience.

Xforce recommends a dyno tune after an exhaust item has been upgraded (like any other power mod) to fully utilize its power potential.


Cat-Back System for EG, EK & EJ

Model: EG & EK Hatch Back and Sedan
Designs:
1)Cannon Rear Muffler: 60mm pipe diameter; Maximum Power; Racing Sound
2)Twin Loop Rear Muffler: 60mm pipe diameter; Maximum Power; Lower Sound output than Cannon muffler; No obvious exhaust noise from cabin on low and mid rpm; Quicker throttle response.









Header (EG/EK D15/D16)
Model: EG-EK B16 engine
Designs:
1) 4-2-1: 38mm-42mm-60mm;increase mid- range power, improved drivability
2) 4-1: 42mm-63mm;Maximize top end power output.





Video: Twin loop sound clip

[Sam98]

Hi,

Will the twin loop system fit the OEM header of an EK4 (diamete: 50 mm)?

Thanks

[matespace]

Hi Sam .

twin loop cat back system should fit oem cat.

[Sam98]

Can you confirm that the inlet is 50 mm of the cat back system (I got an OEM header and I will use a 5zigen decat that is also 50mm)?

How much for the system shipping to New Caledonia?

[matespace]

the xforce twin loop cat back to suit an EK is 60mm with a 3.5" tip. it is design to suit the standard honda oem cat. as long as the your decat is design to suit a oem system everything should bolt up. however xforce can not guarantee its system will fit other brands.

best bet would be to also purchase a high flow xforce cat to suit. For delivery cost please contact xforce directly

email: inquiry@xforce.com.au
Tel: 02 9793 7338

[Sam98]

Ok thanks I'll hit them up!

[ma081010]

hi mate, how much can you do a header for b18c2 on eg?

cheers

[K24EK]

Did you told a price? I'm looking for the same thing

[matespace]

which one ?

[K24EK]

which one ?

for extractors for a b18c in an EG?

[matespace]

you got pm

[johnnyboi87]

hi, just wondering a price for a full exhuast system to suit a ek4 with a b16a2 engine, i was interested in the
4-2-1 headers, with a high flow catback, and a twin loop. i live in melbourne. thanks