Hey guys,

Ive spoken to a few people about this. I have just installed a 4 Point Harness and a Sparco Bucket seat into my DC2. The Harness is using the rear seatbelt anchor points with forged eyelets to clip onto and the Seat is using my standard DC2 rail with a coulp of adaptor plates. Is there any reason why i wouldnt pass and engineering certifiacte. Note: The eyelets for the front mounting of the harness have replaced the standard bolts for the driver side seatbelt so i still have the original front seatbelt in the car.
Also, whats the legality on changing and SRS steering wheel to a non SRS aftermarket system

Thanks
JOE