Amp installation DC2R

[infurNOS]

heres a quick pic of how i have it sitting, i slid the seat all the was forward to get the light to take a good enough photo..

its just a 2 channel pioneer amp, but im pretty sure ve seen 4 channel amps that are this size or smaller now days.

Nice pic, where did you run the ground wire to? Just one of the bolts the seat screws into?

[DCZ 18C]

nahh i ran it further forward behind the front plastics, just looked cleaner

[infurNOS]

nahh i ran it further forward behind the front plastics, just looked cleaner

Was there an exisiting bolt/screw there? Did u have to sand the metal back?

[meangreen]

Sand it a little bit, seat bolts work fine. I'd prefer under the seat for theft reasons + the vibrations from the sub can ruin amps after a while. If you don't want mates etc kicking it just make up a guard to sit in front

[DCZ 18C]

Was there an exisiting bolt/screw there? Did u have to sand the metal back?

hey mate sorry for the lag, and honestly i cant really remember sanding back or not... its been in the car now for about 3 years so its been a while.. but i suppose a little sand back wont hurt..

[Slow.ek1]

listen make ur ground wire shortest as possible the shorter the better less interference and less power loss

[Slow.ek1]

look to do ur amp 1st

*run power cable mount fuse in engine bay
*run remote off back of the h/u along with plugging in ur rca's
*run new speaker wire/sub cable to amp
*sand back a earth no longer that half a meter
*put positive on the battery
and you should be fine

if u have light dimming problems u need to make a second earth from body to battery
if that doesnt work your battery isnt powerful enough maybe upgrade to a drycell optima