Hey guys I recently been in process of replacing my gearbox , which I replaced and found my thrust bearing to be noisy so rippled it all out again and changed it , I reused the gearbox oil I drained and put it back in and now I cannot select gear 3 and 4 at all. It was shifting before in to all gears fine before, it doesn't select when motor is on or off. When installing the bitch pin I used the hammer to jam it in place instead of the power steering bolt trick. I might drain out the oil and replace to see if it has any affect. Really doing my head in. I didn't change anything from before I dunno why it's not shifting ...
Bookmarks