Hi all. I'm in the final stages of finishing this wretched engine drop in to my EG3. The AC bracket I have is the one made by Innovative and it was brought in by the shop who was suppose to finish the drop for me. The issue is, I have a D13B AC compressor and the pulley is too short so the belt it uses crosses over to the main drive belt for the alternator and power steering.

Is there a particular length difference from the compressor housing to the pulley? That is, between the one I have, and the one out of an EK D16Y1? The reason why I ask this, is because the bracket I have is apparently only meant for EKs with a H drop (which I only found out after I got the car back). If anyone can shed some light on this, it'd be much appreciated.