EK1 Front Sway Bar Links, are there any after market parts?

[subie]

Hi guys,

I think my front sway bar links on EK1 need to be replaced, are there any after market ones that I can buy? the small spherical set in the photo below



I looked at Whiteline and Nolathane but none of them

any ideas?

Cheers

[hoojee]

Hardrace has EK front swaybar endlinks $75.

hit up yonas, he'll have some.

[mugen_ctr]

Theres 2 kind of endlinks on the ek's, being ek1 than u will need these type of endlinks, which ive only seen Blox sell the aftermarket set.

[senna]

Or $60 for standard replacement

[dorikin]

Theres 2 kind of endlinks on the ek's, being ek1 than u will need these type of endlinks, which ive only seen Blox sell the aftermarket set.

Nah buddy EK1 uses the double horizontal endlinks in the first post

[subie]

Theres 2 kind of endlinks on the ek's, being ek1 than u will need these type of endlinks, which ive only seen Blox sell the aftermarket set.

Not this type mate, I already looked under the car and i need spherical type as shown in the first photo,

but, thanks anyway

might hit Yonas up anyway

thanks guys

[Mullensxxx]

ej8 and ek's have different front LCAS if people didnt know

function 7 make height adj spherical endlinks, just dont have the dust caps like in your photo, im currently running them in my car ^^

[dorikin]

interdasting, I remember reading something like that on honda-tech but didn't realise it applied to our civics

so EJ8 runs 2-piece LCA and subframe setup like the EG/DC2

what an oddball

[subie]

here's the photo under my ek1



@ mullensxxx, what's the benefit of running Function7 height adj spherical endlinks?

cheers

[mugen_ctr]

interdasting, I remember reading something like that on honda-tech but didn't realise it applied to our civics

so EJ8 runs 2-piece LCA and subframe setup like the EG/DC2

what an oddball

If i remember correctly Only the EM1/EK4/EK9 had the one piece LCA and 26mm swaybar, every other ek/ej model had the 2 piece lca, so therefore if we wanted to go bigger with using the larger swaybar from the em/ek4/ek9 we had to swap the whole LCA, endlinks and pinch fork

So that must mean OP has a ek4???? lol

[hoojee]

^ It's like that for the EK's in the states with their DX, EX etc. etc.

All the variations of EK's in australia (CXI, GLI, VTIR) all seem to use the 1 piece LCA for HB anyways. except the CXI doesnt have the bracket for the endlinks welded on.

[subie]

Thanks for all the inputs guys,

just picked up HARDRACE set from JDMYard for $75

Cheers