***Official What did you do to your ED/EF/CRX today!***

[THE 2BSEEN]

So I found some time to play with the crx in the shed (guna call it lil red).
I picked this crx up for $400 with a seized zc.
I got the spark plugs out and ran some wd40 with some oil.
A few push and pulls and I've got some movement.
Is very tight with 2 and 4
Any ideas for what to do next

[VTI-RRR]

thought id post up hear befor i put it up in the for sale thread got a jdm ef/crx rear bar in awsome condition for sale was gonna fit it to the ed but
needs to be cut and dont wont to do that to this bar. looking at around $150

[trism]

That looks Euro not JDM

You can tell by the number plate hole.

in japan and the US they got a nice small one, because the plates are small.



europe got this one, coz of wide plates.



we ended up with the big one in aus, becAuse the plates are slightly wider than the jdm/usdm ones

[trism]

oh, and the 1.6i-16 gives it away as well, they were only sold with this designation in europe, not japan.

[Kenninho]

reckon the livesport wing looks a bit tacky?

[VTI-RRR]

thanks for the info trism, any one keen?

[trism]

reckon the livesport wing looks a bit tacky?

Yeah its too bulbous.

The J's or chargespeed is thinner, suits the car better.

[pat88c]

thought id post up hear befor i put it up in the for sale thread got a jdm ef/crx rear bar in awsome condition for sale was gonna fit it to the ed but
needs to be cut and dont wont to do that to this bar. looking at around $150

Sorry to tell you it Aus spec ed9 face lift rear bar
still worth something as it has bigger bold strips than preface lift bar

good luck wiith sale

[pengypengy]

anyone know a rough price for a ef fornt conversion on a ed6 thanks

[YeahByuddy]

fai hunred dowla

[Jordang]

Good luck getting out for 500. Closer to 1k I would suggest

[CivicEGSI]

So my engine is in, and everything is plugged in and wired up, but when i try and start it it only cranks once. Any suggestions?