This thread will be to track my progress as i try to reach into the 10's on street tyres.
I think at the moment the Australian street tyre fwd time is around 11.2 seconds. which was set a number of years ago by a swift.
i have previously run 11.78 on my old engine setup which made ~300whp on a gt2871r. This new engine makes a faaatt ~400whp
im hoping to do this with full weight/pump fuel.
update : sat 6/10/12
datalogs and calibration for those with hondata
61012 runs.zip
scholzeycal.zip
as you can see, there is alot of room for improvement!
gotta get the 60ft down to around 1.8 while still protecting my clutch. so i'll have to figure that out.
have to get boost levels closer to there mark, then get traction control dialled in where it wont make my computer hit lean cut from the soft limit it uses.
also need to add full throttle shift.
update 10.10.12 wed night test and tune
getting there slowly.. has power taken out in 1st 2nd and 3rd and i think i can get a better 60ft with these tyres. fresh tyres will def be needed for some good times!
Reply With Quote
Bookmarks