96 spec ITR brake and wheel bearing question

**Alexplicit** · 21-07-2011 10:34 PM

hi guys,

im coming up to my first track day next weekend, and im sick of looking for brake discs, is there seriously no where in australia that sells discs?

is it correct that the VTIR pads will fit my car?

also, my wheel bearings are starting to get noisy what do i replace them with? vtir ones??

thanks

**e240** · 22-07-2011 12:09 AM

'96 spec ITR brakes are 262mm - same as VTiR etc etc... You should be able to just get any 262mm 4x100 unles you're 4 x 114.5
I'd check with Yonas - he's been able to get odd stuff from RDA...LOL

**TODA AU** · 22-07-2011 07:43 AM

96spec ITR is 4 x 114.5

**Alexplicit** · 22-07-2011 07:45 AM

114.3***

**TODA AU** · 22-07-2011 07:55 AM

typo, near enough.... Or did I just parrot type from Leonards post above?

**e240** · 22-07-2011 01:12 PM

LOL - right..114.3...

Given the op did a comversion, he could've just used the calipers and retained 4 x 100
anyway, simple matter to redrill a 4 x100 to 4x113.4

**viinnh** · 24-07-2011 06:21 PM

if cant find 4x114.3, redrill disc ?

**Alexplicit** · 24-08-2011 08:31 AM

ok and as for the wheel bearing?

**mrcrvk24** · 10-01-2012 01:24 AM

I need some info about wheel bearings too cant find any

**JPR28610** · 10-01-2012 07:05 AM

All 4 stud dc2 use the same wheel bearing

**Alexplicit** · 25-10-2012 07:04 AM

reviving my old thread...

since then, i luckily found another set of 96 spec rotors.... buuuut... i want to upgrade again, however i want ot keep 114.3.... CAN i, get a set of VTI-R rotors, and redrill them to 114.3?