looks good, doesnt a silver one cause more heat though?
because back in the day lots of enthusiasts were chroming everything under the hood and then run into the problem of overheating because so much heat was just being bounced around under the engine bay.
i just did an attempt at vinyl wrapping my car, as i noticed some bubbles i peeled it back to let them out and it ripped of alot of clear coat.
be weary dont press it down hard on installation wait until its sitting how u want then begin to force it down.
Use a heat gun to mould the vinyl. if there are bubbles use a pin to poke a small air hole in it.
That's the technique they used when I had mine done professionally.
Just installed some 6" MB Quart NAN-116 2 way speakers in the rear of the Prelude. They've got a lot better response than the crap 5" Pioneer things I had in there before hand.
Next up will be some splits for the front.
Something like this, hopefully they aren't too large. http://www.ebay.com.au/itm/190750831...=p5197.c0.m619
Measure the depth of the speaker hole thats already in there. There have been some cases that people have got speakers that are to deep and the window doesnt close and open properly
Measure the depth of the speaker hole thats already in there. There have been some cases that people have got speakers that are to deep and the window doesnt close and open properly
Yeah thanks, I'll have to check all that out before I purchase the splits.
Bookmarks