brake/5 stud eg help

[kane30]

hey people recently bought an eg for a project it has discs on the front and drums on the back just wondering if i can use dc2 parts for the conversion, what exactly do i need?
and i heard theres a **** around with the handbrake cables?
thanks any help would be good

[duzy]

Yea you can use dc2 parts. You'll need the whole trailing arms and everything on it as they will simply bolt up to eg.
Best way is to find an integra vtir wreck and take every brake component it has, front and rear setup, master cylinder brake booster, prop valve hand brake lines and brake lines.
Seen a few setups go for about $500-600ish on here.

And if you want more braking power after that, you can simply upgrade to 282mm rotors from the integra type r but retain the 4x100 setup
http://www.ozhonda.com/forum/showthr...o-280mm-brakes

[kane30]

i think i want to go 5 stud tho but thanks for the help that helped a shitload and do you no anything about the handbrake cables?

[justin333]

i think i want to go 5 stud tho but thanks for the help that helped a shitload and do you no anything about the handbrake cables?

what are u going to run on the EG mate?

DC2R 5 stud will be bolt was told by my friend who has done a B16 conversion

[kane30]

ok cheers

[viinnh]

AUDM DC2R will be bolt on, JDM DC2R wont work with your drive shafts as they are 36mm and for the hand brake lines, change them to the EK one and it will work. DC2R ones are longer