Disclaimer: The following is provided as a GUIDE ONLY, and neither myself nor Ozhonda take any responsibility for the outcomes of someone else doing the following. You follow these steps at your own risk!
Aim: Lift your EK9 wing up a bit with out using the brackets which look like shit
Required: spacers/nuts/gromets
Steps:
-Remove your stock EK wing by removing the plastic under the boot then the 4 screws
(NO PIC)
-Take off the base plate from the ek9 wing and add spacers/nuts/gromets/whatever you want to slide on to the rear stud on both side. the more it is the more lifted the wing
-Here I have just added enough to be inline with the stock stud. Put the base plate back on and bolt it down using the other stud
-Final result
That little tilt makes a big difference in real life
From the back still looks stock with out that weird bracket look
Couldn't get the best photos and angle as theres another car in the way to get a side on shot
For OEM or spoon wing refer to this DIY I have made.
http://www.ozhonda.com/forum/showthr...ock-EK-LIfters
Bookmarks