clutch thrust bearing

[monda2]

Hi All

I have purchased a clutch masters stage 1 kit with flywheel, all good but the thrust bearing is very different to the oem bearing as per photos, I cannot see how the spring attaches? and the depth of the new bearing is 30mm and the depth of the oem is 34mm?

Also, I have heard some peeps purchase brand new flywheel to crank bolts and others do not? whats best?



any help appreciated

Cheers

[u mad?]

Fine to reuse old flywheel bolts, just clean them and maybe chuck a dab of loctite red for piece of mind.

Only torque to yield bolts should be replaced every time, which our honda do not use on the flywheel bolts.

[monda2]

ok defiantly put some loctite on, any recommendations on the thrust bearing issue?

forgot to state its a b16a, if that matters

[u mad?]

Sorry have no idea, maybe contact the supplier, im sure they will be able to help. Otherwise, maybe someone can chime in on here.

[mocchi]

u got cable gearbox, the bearing u got from clutch masters is for hydraulic gearbox

[monda2]

yea mine is cable, clutch masters said it could be used for either? I wasn't sure about this initially but he was adamant its should be fine

[mocchi]

yea mine is cable, clutch masters said it could be used for either? I wasn't sure about this initially but he was adamant its should be fine

nah cant use it cos the fork is different.

[u mad?]

mochi deadliest kunt