So I came across some brembo calipers for cheap and instantly jumped on them.
I've seen numerous times how people mount them by just milling 7.5mm off the caliper mounts.
I was definitely not going down that route.
Had a friend of mine machine up some 7.5mm spacers to slide in before the rotor, which would effectively make the offset of the rotor suit the dc5 calipers. also the screws that hold the rotor down I manage to find some longer ones.

Although going this route would make it much more safer, but meanwhile I'd be loosing 7.5mm off my studs for my wheel nuts to grab onto.
So i ordered some extended studs, and as we all know once the hub is pulled apart the wheel bearings would instantly collapse. so I had to order some new wheel bearings also..

and here is the outcome..


screen grab


photo sharing sites


free picture upload