How to install V3 Triton Rear blinkers for FK/FN

What you will need
VLED V3 Triton Amber LED system
Small hands
A Phillips Screw driver.
A torch
Adhesive Thermal tape

If you want to add the triton rear blinkers you will need the following.
The V3 Trion system.
The Base you will need is 7440/7443

1: Start by removing the control box and installing the base connector(note: if the model does not work, rotate the base connector 180°)


2: Remove the screw cover and then remove the screws for the rear housing.


3: Insert the LED module into the connector.


4: Install screws to match the tabs on the connector


5: Install the thin narrow gasket.


6: Add some thermal transfer tape to the control box and add a fuse to the load resistor fuse holder.


7: Clean the metal behind the bumper with some IPA and stick down the control box.


Before


After: