Results 1 to 3 of 3
  1. #1
    Member Array
    Join Date
    Jul 2012
    Location
    MIA
    Car:
    DC2R

    Dc2R drive shaft issues

    During the track day yesterday my drive shaft came out twice while taking a corner. Unsure if its due to spinning out and sliding on the grass earlier. We managed to put it in again and it was fine for the drive home.
    My question is the drive shaft faulty or the place it locks into in the gearbox?

    Cheers

  2. #2
    Car is very low ?
    The C clip on the driveshaft end might be old/worn
    Or lower control arm bushes also worn or broken

    All the above givin excessive play in the shaft when concerning can pluck it out quite easily

    At least you wouldn't of lost fluid as the LSD box diff housing is sealed up pretty good compared to a open diff. I'd check your tranny fluid level just to be safe

  3. #3
    Member Array
    Join Date
    Jul 2012
    Location
    MIA
    Car:
    DC2R
    Car is very low ? - stock hieght
    The C clip on the driveshaft end might be old/worn
    Or lower control arm bushes also worn or broken

    All the above givin excessive play in the shaft when concerning can pluck it out quite easily - Cheers will look into it.

    At least you wouldn't of lost fluid as the LSD box diff housing is sealed up pretty good compared to a open diff. I'd check your tranny fluid level just to be safe - Topped it up on to spot

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Powered by vBadvanced CMPS v4.1.3


Terms and Conditions
Ozhonda.com is in no way affiliated with the Honda motor company or Honda Australia in anyway whatsoever.