EP3R: Specifications for valve clearances

**blackdc2r** · 12-09-2015 04:32 PM

Just wondering what are the clearance for the intake and exhuast valves? Need my tappets adjusted for a service.

**amant02** · 13-09-2015 01:58 AM

Theres a sticker on the hood with this info. If not Google for 'k20a valve clearance' u will have ur answer within few moments of reading.

**blackdc2r** · 13-09-2015 08:01 PM

Theres no sticker that shows this info. I just checked. Well the thing was i couldn't find the spec's for the JDM ep3r. I only found one for the DC5r and EP3 UK model.

**amant02** · 13-09-2015 09:57 PM

Intake: 0.21 - 0.25mm (0.008 – 0.010 in.)
Exhaust: 0.25 – 0.29mm (0.010 – 0.011 in.)

I will need someone more knowledgeable to confirm.

There should be a sticker under your bonnet with this info. All my Honda's have had this from my eg all the way to my dc5r.

If it dsnt have the sticker, I would suspect some sort of repairs have been carried out on the car, but hey it is only a sticker after all could be washed off.

**RenzokukenJ** · 13-09-2015 10:55 PM

Um wut

**amant02** · 13-09-2015 11:08 PM

Why else would one remove that sticker. I mean its on there pretty good. I've washed over it few times too and still stayed on there.

**bennjamin** · 14-09-2015 07:58 AM

Originally Posted by amant02

Why else would one remove that sticker. I mean its on there pretty good. I've washed over it few times too and still stayed on there.

Sticker sits under the bonnet , on the bare metal rather than the heat padding....it can't be washed off

Likely reason for no sticker is an aftermarket and or repaired bonnet.