***HELP***Trying to fit an EG B16a into an EK

[danny]

Hey Guys

I need urgent help, i'm in the middle of trying to put a B16a out of an EG into my 96 Ek civic coupe (SOHC vtec)

i have the wring and ecu i know i need engine mounts, but wiring loom do i use cause the Eg B16a ECU dosen't fit my dash wiring, and alsomy SOHC wiring loom wont fit the b16a.....

what to do?

has anyone done this before

[heist]

dude, i hope you know you cant fit an engine that is older than the chassis in you car. it will be illegal, unless its a race car.

so u wanna sell it to me?

[danny]

na don't wann sell it......

just need help putting it in..........

[z3lda]

edit. someone bet me to it

[danny]

that has been mentioned yes....

still need help putting it in though

[Kawasaki]

if you don't mind me asking... why are you putting an illegal engine into your car?

[danny]

not my car personally wouldn't do it for my car....i'm doing the conersion for mate and i have him told a billion times =...but he dosen't care so..neither do i.............


i just need help putting it in.............

[Chi]

You shouldn't do it for him.

Just in case he gets caught gets you drawn into it as to helping him with it.

[danny]

he is a good mate and and dosen't no thtat much about cars.....i thought it would be a bolt in.....turns out i'm have prob with the wiring.....

anyway if someone could that would be great.........

[Chi]

The other [Danny] on this forum has done a similar DIY conversion.

PM him about it

[danny]

do anyone one have an idea?

[CTR Coupe]

you need ek VTI-R engine mounts.

can some one direct me to the part of the modifcation guidelines that says the engine has to be newer than the car? i think you guys have been reading too many american forums.